E-Tech ET8 Especificações descarregar pdf (Página 544)

100

101

510 IBM BladeCenter JS23 and JS43 Implementation Guide

2. Identify the World Wide Port Name and/or World Wide Node Name.

3. Set the connection type.

4. Set the transfer rate.

5. Query available targets.

This appendix is split into a section about the QLogic host bus adapter and the

Emulex host bus adapter. We start with a description of how to get access to the

Open Firmware prompt.

Get access to the firmware prompt

Use a console of JS23/JS43 and power on or restart the blade. See “Graphical

console” on page 494 or “Serial Over LAN” on page 500 about available

consoles. “System Management Services menu” on page 501 describes how to

power on a blade.

When the blade shows the POST, enter 8 to get access to the Open Firmware

prompt. During POST the words Memory, Keyboard, Network, SCSI, and

Speaker are written to the console, as shown in Example A-3. When this

happens, enter 8 before the word speaker appears. The JS23/JS43 does not

show the service request codes on the console, as JS20 or JS21 do. These

SRCs are shown in the Web interface of the Advanced Management Module.

The content of Example A-3 is the only information shown during POST.

Example: A-3 IBM BladeCenter JS23/JS43 POST

IBM IBM IBM IBM IBM IBM IBM IBM IBM IBM IBM IBM IBM IBM IBM IBM IBM IBM IBM

1 = SMS Menu 5 = Default Boot List

1 2 ... 539 540 541 542 543 544 545 546 547 548 549 ... 617 618

Comentários a estes Manuais

Sem comentários

E-Tech ET8 Especificações Página 544

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso E-Tech ET8