E-Tech ET8 Manual de Instalação descarregar pdf (Página 55)

E-TECH RADIO

E-TECH ET8 (V4) CONTROL PANEL – INSTALLER MANUAL

RADIO DEVICES – OPERATION

ALARM: Any E-Tech Radio Device can operate on any zone 1–8 as programmed by

P01E~P08E. The hardwired zones 1–8 continue to operate in parallel.

Radio Keys can also operate on radio zones 1~8 for special purposes, but they should

normally be used as Radio Codes.

KEYSWITCH INPUT: A Radio Device programmed to Zone 8 will still work as an alarm even

if the Zone 8 input operation has been changed to Keyswitch operation. The P60E 2E and

3E options only affect the Zone 8 terminal inputs.

VIBRATION: Radio device zone signals IGNORE the P30E–P38E vibration sensor settings.

TAMPER REPORT: Radio Device Tamper operation depends on the Armed State of the

control panel.

RADIO TAMPER: causes the keypad to continuously beep and also to flash the RADIO,

TAMPER and the ZONE (identifying the detector) lights. Pressing any key on the keypad or

sending a TAMPER RESTORE will clear this warning.

LOW BATTERY REPORT: A low battery gives 10 beeps and flashes the RADIO & the

BATTERY light. The ZONE light identifying the radio device is also ON. The flashing lights

stop when any key on the keypad is pressed or a detector code with no low battery is

received. Low Battery generates HISTORY and DIALLER reports ONCE only (until the low

battery is fixed and a restore report is received).

SUPERVISION: If a zone has the P65E option ON and a radio code has been programmed

for that zone, then the supervision is active. This means that the radio detector does not

need to have its SUPER enabled (via header link) for the SUPERVISED timeout to occur.

(Useful as an inactivity alarm). A zone supervision failure always flashes the identifying

ZONE light and the RADIO light.

RADIO KEY

PENDANT

100-665

RADIO KEY

3 BUTTON

100-664

RADIO PIR

100-663

RADIO

REED SWITCH

100-662

RADIO SMOKE

DETECTOR

100-203

SIGNAL

TYPE

E-TECH RADIO DEVICES

Signal types transmitted

ALARM

ON button

OFF button yes yes yes

yes yes yes yes yes

yes yes

yes yes yes

ON button yes yes yes

RESTORAL

LOWBA TT

TAMPER

SUPERVISION

RADIO SUPERVISION

The purpose of Radio Supervision is to verify the correct operation of E-Tech

Radio PIRs. The Supervision signal from the Radio PIR tells the panel that the

device has not been removed from radio range and is in working order.

Non-SUPERVISION Radio PIRs can also be programmed and used with the ET8

SUPERVISION TIMERS.

A non-SUPERVISION enabled Radio PIR will transmit signals to the ET8 only

when it has detected an event. Obviously, there is no guaranteed signal period.

In either case, when the allowed time limit is exceeded then a WARNING is first

given (if programmed by P66E 3E), and then after 1 minute, the programmed

RADIO SUPERVISION ALERTS are generated by the ET8.

NOTE: Manually Excluding a Supervised Zone will also disable Radio

Supervision for that zone.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 63 64

Comentários a estes Manuais

Sem comentários

E-Tech ET8 Manual de Instalação Página 55

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso E-Tech ET8